PDA

View Full Version : when I open a thread in the forum...


Sensei
06-28-2015, 09:56 PM
On an unrelated note, I haven't been poring over the site as much as usual recently, so maybe this has been addressed and someone can point me to the answer. How come when I open a thread in the forum, it takes me to somewhere in the middle of page 2? Is there a quick fix to get back to the old way of opening up immediately to the most recent post? TIA.
konakathy
06-28-2015, 10:06 PM
On an unrelated note, I haven't been poring over the site as much as usual recently, so maybe this has been addressed and someone can point me to the answer. How come when I open a thread in the forum, it takes me to somewhere in the middle of page 2? Is there a quick fix to get back to the old way of opening up immediately to the most recent post? TIA.

I don't think a fix was found. I seem to intermittently have the same problem, but then again, I seem to be having a few problems with the forum using my Mac.:worried:
userque
06-28-2015, 10:46 PM
On an unrelated note, I haven't been poring over the site as much as usual recently, so maybe this has been addressed and someone can point me to the answer. How come when I open a thread in the forum, it takes me to somewhere in the middle of page 2? Is there a quick fix to get back to the old way of opening up immediately to the most recent post? TIA.

For giggles, and if you haven't already, try toggling AND THEN SAVING this setting (in General Settings). Then toggle it back AND SAVE.

34266
tsptalk
06-28-2015, 11:07 PM
On an unrelated note, I haven't been poring over the site as much as usual recently, so maybe this has been addressed and someone can point me to the answer. How come when I open a thread in the forum, it takes me to somewhere in the middle of page 2? Is there a quick fix to get back to the old way of opening up immediately to the most recent post? TIA.
http://www.tsptalk.com/mb/report-problems/22478-link-post-order-problem.html
Sensei
06-29-2015, 07:33 AM
OK, thanks to all for your input. I screwed around with the settings - it seemed like it was configured right to begin with, but I changed some things, then changed them back, and all is working as I remember it. Thanks again.